Kohler RDT User Manual

4 TT-1403 4/16
2.2 Mounting, 400 Amp Model RDT,
Service Entrance Rated 200 Amp or
400 Amp Model RDT
SeeFigure4.
1. Replace the existing mounting bracket with bracket
GM64055 provided with the kit. See Figure 4.
2. Insert the timer through the opening in the bracket.
Secure the timer to the four standoffs using four
mounting screws X-49-2 provided with the kit.
3. Proceed to the Wiring Section for timer
connections.
GM47597
2
1. Bracket GM64055
2. Timer GM64028 with screws X-49-2 (qty. 4)
1
Figure 4 Mounting, 400 Amp Model RDT or 200
Amp and 400 Amp Service Entrance Rated
Model RDT
2.3 Mounting, Models KSS-J with
Decision-Makerr MPAC 750 Controller
1. Align the mounting holes on the timer bracket
GM89060 with the two mounting studs on the
inside of the transfer switch box. See Figure 5.
1. Secure the timer kit to the studs with the two
X-6210-2 nuts provided with the kit. See Figure 5 .
2. Proceed to the Wiring Section 3.2 for timer
connections.
GM46745
1. Bracket GM89060
2. Nut X-6210-2 (qty. 2)
3. Mounting Stud
3
2
1
Figure 5 Mounting, Models KSS-J with
Decision-Makerr MPAC 750

Kohler RDT Specifications

General

Model	RDT
Category	Switch
Type	Dimmer
Wall Plate Included	No
Voltage	120V
Wattage	600W
Compatibility	LED, CFL, Incandescent