SC200 Installation& Operation Manual 3-16
13
Cleaning Mode Start Up
At power up in the wash mode the electronic control will monitor the following criteria:
If the water plate is not in the full up (closed) position at start up, the controller will close the plate.
If there is ice on the surface of the water plate, preventing it from closing, the controller will
reopen the plate to clear it.
Storage and Winterization
Clean and sanitize the ice machine.
Disconnect the electric power supply.
Disconnect water and drain lines.
Remove and empty the water sump.
Open water valve and dump valve and blow compressed air through all lines.
Remove and drain the water plate assembly.
Reassemble water plate assembly and water sump.
Replace all cabinet panels.
Removalfrom Service
When the ice maker is determined to be no longer useable please be sure that it is rendered safe
for storage or disposal. All applicable recycling measures should be exercised to avoid injury and
harm to the environment.
The manufacturer and/or seller is not responsible for any harm to people, animals, property, and
the environment caused by incorrect installation and/or disposal.
To Next Page
Loading...
