Kolida K3 IMU User Manual

K3 IMU
- 20 -
Self-check: Users can also do the self-check from this configuration page, click on the Check all
button to check all the modems or click on the check button corresponding to the modem to check
one by one.
Clean EPH: Click this button to clear the remaining epochs to let recever track the satellites
better.
Factory Default: Click this button to bring the receiver back to factory default setting.
Reboot: Click this button to restart the receiver.
Power Off: Click this button to power off the receiver.
System Setup
This page is used to control Voice prompt, volume of voice, power saving and the default
language for receiver.
Voice Prompt: Check on this box to turn on the voice guide, uncheck it to turn off the voice guid.
Voice Volume: Define the voice volume for K3 IMU’s speaker.
Power: Configure the receiver to use the power saving mode or not.
USB: The Type-c interface of K3 IMU is set to USB disk and network interface mode at the same
time, no need to set up it for K3 IMU.When connected to the computer, you can open internal
memory and runweb Ui at the same time for K3 IMU.
Default Language: Configure the default language for K3 IMU which associates with voice guid.
Time Zone (h): Use this to setup the corresponding time zone for your country or area.

Kolida K3 IMU Specifications

General

Brand	Kolida
Model	K3 IMU
Category	Measuring Instruments
Language	English