K3 IMU
§2.2 Indicator and buttons
Control Panel
2.Confirm working mode and data link.
3. Perform general settings on the receiver.
4. Always on when power on, flashing on low power.
Rover Mode: Flashes red light when the correction
data is received but not Fixed solution.
Flashes green light after getting Fixed solution.
Base Mode: Flashes red light when there is differential
data transmission.
Static mode: Flashes by the data sampling interval to
indicate the data file is recording.
Glows in blue to indicate that Bluetooth connection has
established between controller and receiver.
§2.3 Check the remaining power
When K3 IMU is charging, the corresponding light flashes before charging to the corresponding
power. Press the power button once, the current battery level will show several lights.
For example, when the battery is fully charged, the four lights of 25%, 50%, 75%, and 100% are
all green on. When the battery is 60%, press the power button once, and the 25% and 50%
indicator lights will be red on.
To Next Page
Loading...
Need help?
General
