What to do if Kolver EDU 2AE/TOP/TA displays “Error missing piece”?
If your Kolver Control Unit displays “Error missing piece”, it indicates that the “missing piece” contact is enabled. To address this, check contact 2 on the CN2 connector.
What to do if Kolver EDU 2AE/TOP/TA Control Unit displays “tightened screw”?
If your Kolver Control Unit displays “tightened screw” on the status bar, and the torque signal is displayed during the motor startup process (which lasts 0.3 seconds), you should check the parameters again.
How to fix Kolver EDU 2AE/TOP/TA Control Unit when “waiting connection” doesn’t turn into “system ready”?
If your Kolver Control Unit displays “waiting connection” and does not switch to “system ready” after being turned on, check the flat connector inside the unit.
What to do if my Kolver Controller shows “Output Disabled”?
If the Kolver Controller displays 'Output Disabled', it means the protection of output signals was activated because the maximum load (400mA) was exceeded. To resolve this, verify that the set load does not surpass the maximum allowed value. Then, restart the control unit to reset the error.
What does “Protection 15A” mean on my Kolver Controller?
If the Kolver Controller displays “Protection 15A”, it indicates that the current on the mosfets of bridge H exceeded 15A for at least 500ms. To address this: - Decrease the screwing time and check the settings. - Avoid motor stalling. - Ensure unscrewing isn't too heavy. - Check if the joint is too soft.
What causes “Protection 14p5A” error on the Kolver Controller?
The “Protection 14p5A” error on the Kolver Controller indicates that the current on the mosfets of bridge H is greater than 14.5A for at least 800ms. Suggested solutions include decreasing the screwing time, checking settings, avoiding motor stalling, ensuring unscrewing isn't too heavy, and verifying the joint isn't too soft.
How to fix “Protection 12A” error on a Kolver Controller?
If the Kolver Controller displays “Protection 12A”, it means the current on the mosfets of bridge H is greater than 12A for at least 1 second. You should decrease the screwing time and check the settings, avoid motor stalling, ensure unscrewing isn't too heavy, and verify the joint isn't too soft.
What to do if Kolver Controller shows “Error Torque Control”?
If the Kolver Controller displays “Error Torque Control”, make a new screw. If the error persists, change the torque and speed settings.
Why does my Kolver Controller display "Torque / Speed Error" in Unit mode?
If the Kolver Controller displays "Torque / Speed Error" in Unit mode, it means a torque or speed has been set which is not included in the table relating to the selected screwdriver. Set a torque or speed value included in the range indicated in the table to resolve this issue.
General| Brand | Kolver |
|---|---|
| Model | EDU 2AE/TOP/TA |
| Category | Control Unit |
| Language | English |
To Next Page
