EXPLANATION OF COMPONENTS OPERATION
3-32
SHIFT MODE SWITCH
Use this switch (5) to switch the shift mode.
For details, see“DISPLAY PANEL A (SPEED RANGE, SET
TRAVEL SPEED, SHIFT MODE INDICATOR) (3-15)“.
STARTING SWITCH
The switch (6) is used to start and stop the engine.
OFF position:
At this position, the starting switch key can be inserted and
removed. When the switch is turned to this position, all the
electric circuits are turned off and the engine stops.
ON position:
In this position, electric current flows in the charging and lamp
circuits.
Keep the starting switch key at the ON position while the
engine is running.
START position:
This is the position to start the engine. Hold the key at this position while cranking. Release the key immediately
after the engine has been started. The key will return to ON position when released.
HEAT position:
When starting the engine in cold weather, set the switch to this position. If the key is kept at the HEAT position, the
engine preheating pilot lamp will light up.
Keep it at the HEAT position for the specified preheating time.
For details, see “STARTING IN COLD WEATHER (3-79)“ in OPERATION portion.
HORN SWITCH
The horn sounds when the button (7) at the rear of the blade
control lever at the right side of the operator's seat is pressed.
To Next Page
Loading...
