.
EXPLANATION OF COMPONENTS
EXPLANATION OF COMPONENTS
When the buzzer cancel switch is operated to ¯, the contrast of
the liquid crystal display is set.
4.
Mode to set tilt limit (dual tilt machine)
The diagram on the right is the mode used to set the tilt limit.
The method for setting the tilt limit is as follows.
METHOD OF ENTERING USER ADJUSTMENT MODE AND METHOD OF ENTERING TILT LIMIT ADJUSTMENT MODE
1.
Turn the starting switch ON.
2.
Hold the buzzer cancel switch at the SELECT position (¯) for 3 seconds.
(This enters the user adjustment mode)
3.
When the information switch is turned to the right or left, the service mode on the multi-information display
changes, and 04:TILT LIMIT is displayed.
Following this, if the buzzer cancel switch is operated to the SELECT position (¯), the system enters the control
adjustment mode, but before starting, there are operations necessary for adjusting the tilt limit, so follow the
procedure below.
METHOD OF ADJUSTING TILT LIMIT
1.
Start the engine, use the toggle switch on the work equipment control lever to select DUAL TILT, tilt the work
equipment back fully, then lower it to the ground.
2.
Operate the buzzer cancel switch to the SELECT position (¯) to enter the tilt limit adjustment mode.
When the pitch switch on the work equipment control lever is pressed, the buzzer sounds and the basic position
of the work equipment is saved to memory.
3.
Raise the work equipment 1000 mm (39.4 in), then tilt it 12° to the left.
In this condition, use the toggle switch on the work equipment control lever to switch to SINGLE TILT, then
switch back to DUAL TILT. The buzzer sounds and the left limit position is saved to memory.
4.
Set the buzzer cancel switch to the CANCEL position (¢) to exit the tilt limit adjustment mode.
5.
Operate the work equipment to pitch dump to set to the full pitch dump position. (Keep the work equipment
horizontal.)
6.
Operate the buzzer cancel switch to the SELECT position (¯) to enter the tilt limit adjustment mode again.
7.
Raise the work equipment 1000 mm (39.4 in), then tilt it 12° to the right.
8. In this condition, use the toggle switch on the work equipment control lever to switch to SINGLE TILT, then
switch back to DUAL TILT. The buzzer sounds and the right limit position is saved to memory.
This completes the adjustment operation, so set the buzzer cancel switch to the CANCEL position (¢) to exit
the tilt limit adjustment mode, then lower the work equipment to the ground and stop the engine.
To Next Page
Loading...
