EA 600 / Base version
70
857-164688 / E
6.2 Cable plans and specifications
Configurations
The system cables are identified in following cable plans. Each
cable is identified with a cable number (Cx). Further
information about the cable (connections and specifications)
may be found on the referenced page(s).
The following main configurations are available:
• Basic
• Hydrographic Operator Station
• GPT Cabinet
Several variations may be built based on these main
configurations.
Basic
The basic configuration comprises a single General Purpose
Transceiver (GPT), a Processor Unit and a display. An optional
Ethernet HUB or switch is added for interface purposes.
If two GPT units are required, the Ethernet switch must be
installed.
Hydrographic Operator Station (HOS)
This configuration comprises a 15- or 18-inch display with a
built-in Processor Unit. It is otherwise identical to the basic
configuration.
GPT Cabinet
The GPT Cabinet configuration uses a steel cabinet to provide
IP55 protection. One or two GPT units may be installed in the
cabinet, as well as an Ethernet switch if required.
To Next Page