Konica Minolta bizhub 3301P - Page 100

User's Guide
- 100 -
Use
To
Error Recovery
Auto Reboot
Reboot when idle
Reboot always
Reboot never
Max Auto Reboots
1–20
Set the printer to restart when an error occurs.
Notes:
• Reboot always is the factory default setting for Auto
Reboot.
• 2 is the factory default setting for Max Auto Reboots.
Print Recovery
Auto Continue
Disabled
5–255
Let the printer automatically continue printing from certain
offline situations when these are not resolved within the
specified time period.
Note: Disabled is the factory default setting.
Print Recovery
Jam Recovery
On
Off
Auto
Specify whether the printer reprints jammed pages.
Note: Auto is the factory default setting. The printer reprints
jammed pages unless the memory required to hold the pages
is needed for other printer tasks.
Print Recovery
Jam Assist
On
Off
Set the printer to automatically check for jammed paper.
Notes:
• On is the factory default setting. This sets the printer to
automatically dump blank pages or partially printed pages
to the standard bin after a jammed page has been
cleared.
• Off requires the user to remove all pages from all possible
jam locations.
Print Recovery
Page Protect
Off
On
Successfully print a page that may not have printed otherwise.
Notes:
• Off is the factory default setting. This prints a partial page
when there is not enough memory to print the whole page.
• On sets the printer to process the whole page so that the
entire page prints.
Press Sleep Button
Do nothing
Sleep
Hibernate
Determine how the printer, while in idle state, reacts to a short
press of the Sleep button.
Note: Sleep is the factory default setting.