bizhub C360/C280/C220 (Version 4) 14-19
14.8 Using extension lines
14
14.8 Using extension lines
If two Fax Kit FK-502 are installed, configure settings for the second line.
[Multi Line Settings]
In the administrator mode of PageScope Web Connection, select [Fax Settings] ö [Multi Line Settings].
Item Description
[Line Parameter Set-
ting]
Configure line parameters for the extension line.
[Dialing Method] Select a dialing method for the extension line.
[Number of RX Call
Rings]
Specify the number of quasi-ring back tone count between fax arrival and the
start of reception.
[Line Monitor Sound] Specify whether to hear the line sound from the speaker during communica-
tion.
[Function Setting] Configure settings for the extension line function.
[PC-FAX TX Setting] Select the line used for PC-FAX transmission.
[Number Display Func-
tion]
This item is not available.
[Name Display Func-
tion]
This item is not available.
[Multi Line Usage Set-
ting]
Configure the operation settings of Line 2 (an extension line).
[Line 2 Setting] Specify the communication method for Line 2 (an extension line).
You can specify [TX Only], [RX Only], or [TX and RX] for an extension line.
[Sender Fax No.] Enter the fax ID (up to 20 characters, including + and space).
Usually enter the fax number of the fax machine.
The registered fax number is printed as the sender information on the fax re-
ceived by the recipient.
To Next Page
Loading...
Need help?
General
