To Next Page
J
Justin CarrSep 12, 2025
What does “ D AT E E R - ROR” mean on Konica Minolta Measuring Instruments?
- PPamela Combs DDSSep 12, 2025
Turn the power OFF, and then turn it ON again. If this symptom still occurs, the instrument has broken down.
What does “ D AT E E R - ROR” mean on Konica Minolta Measuring Instruments?
Turn the power OFF, and then turn it ON again. If this symptom still occurs, the instrument has broken down.
Why calibration values differ on Konica Minolta CA-100Plus?
If the calibration values differ, it may be due to the Lv value of the calibration values for low luminance. If a low-luminance value is used as the calibration value, this symptom may occur due to calculation error.
Why Probes P2 to P5 cannot be selected on Konica Minolta CA-100Plus?
If you cannot select Probes P2 to P5, check the following: * Verify that the 4-Probe Expansion Board is installed correctly. Install it correctly. * Ensure that the measuring probes are properly connected to the probe connectors [P2] to [P5]. Connect necessary number of probes to the probe connectors properly.
General| Type | Color Analyzer |
|---|---|
| Measuring Area | 8 mm |
| Measurement Time | Approx. 0.5 sec |
| Display | LCD |
| Power Supply | Battery |
| Weight | 500 g |
