EasyManua.ls Logo

Konica Minolta DiMAGE Z2 - Macro Photography Modes

Konica Minolta DiMAGE Z2
124 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
35
macro
Approximate location of CCD
plane
Wide-angle position: 14 - 107cm (6.7 - 42.1 in.)
Telephoto position: 127 - 257cm (50.0 - 101 in.)
Super-macro indicator
Two macro modes are available: Super Macro and standard
macro. Super Macro allows the camera to focus as close as 3
cm (1.7 in.) from the front of the lens or 10 cm (3.5 in.) from the
CCD. When Super Macro is selected, the lens automatically
zooms to the 11.1mm focal-length position and cannot be
changed. Standard macro allows the zoom to be used. The
minimum focus distance changes with focal length, see below.
Press the macro button (1) to select the macro mode. The
modes cycle among standard macro, Super Macro, and off.
The following chart lists the Super Macro and standard macro
ranges. All distances are measured from the CCD.
10 - 107cm (4.3 - 42.1 in.)
Super Macro (at a focal length of 11.1mm)
Standard macro
Innovation and creativity is the cornerstone of Minolta’s success.
The Electro-zoom X was an exercise in camera design and
received a great deal of attention when it was unveiled at
Photokina in 1966.
The Electro-zoom X was an electronically controlled aperture-pri-
ority mechanical SLR with a built-in 30 - 120mm f/3.5 zoom lens
giving twenty 12 X 17mm images on a roll of 16mm film. The shut-
ter-release button and battery chamber are located in the grip.
Only a few prototypes were built making it one of Minolta’s rarest
camera.
Konica Minolta History
1

Table of Contents

Related product manuals