Korber Solutions LTI MOTION ServoOne CM - Mounting Clearances

14
Mechanical installation
Operation Manual Expansion Module SO CM-E
1800.202B.0-01 Date: 02/2019
1
2
6
7
4
3
5
1.) MotionOne CM controller
2.) ServoOne CM-P supply unit BG3
3.) ServoOne CM-C capacitance module (optional)
4.) ServoOne CM axis controller BG3
5.) ServoOne CM axis controller BG4
6.) ServoOne CM-E expansion module
7.) Poss. ServoOne CM axis controller BG1+2
Figure 3.1 Butt mounting sequence
3.2 Mounting clearances
CAUTION! Damage to the device due to incorrect installation conditions!
The device may suffer irreparable damage if the conditions are not met.
• The minimum clearances stated in the gure below apply to the entire ServoOne CM
multi-axis system. The distances are primarily dened by the ServoOne CM-P BG3+4 and
ServoOne CM BG3+4 devices.
• The clearance above the devices is important to prevent the build-up of heat. The clearance
underneath and at the front is necessary to permit correct cable laying.
≥ 150
≥ 200
*)
SO CM-P-BG3
SO CM-BG3
≥ 300
Figure 3.2 Mounting clearances ServoOne CM