Korber Solutions LTI MOTION ServoOne CM - Certifications; CE Certification; UL Certification; Connection System

33
Appendix
Operation Manual Expansion Module SO CM-E
1800.202B.0-01 Date: 02/2019
A.4 Certications
A.4.1 CE certication
The ServoOne CM-E expansion modules conform to the requirements of the Low
Voltage Directive 2014/30/EC and the product standard EN61800-5-1.
They thus conform to the requirements for installation in a machine or plant under the
terms of the Machinery Directive 2006/42/EC.
The expansion modules are accordingly CE marked. The CE marking on the rating plate
indicates conformity with the above directives.
A.4.2 UL certication
You will nd information on the certication according to UL 61800-5-1 for the
ServoOne CM-E expansion module in the document "UL-Certication"
ID no.: 0927.01B.x. (Not yet available at the time of going to press).
A.5 Connection system
A.5.1 Connection cables for communication
This connection cable is required for cross-communication (internal system cross-
communication).
Specication:
• Length 240 mm
• Connector 2 x RJ10
Figure A.1 Specication type: XCOM
A.5.2 Pre-assembled DC link cable, expansion modules
This cable is used to establish a DC link connection between two expansion modules
SO CM-E.x0xx.1 "Dual" and SO CM-E.x0xx.2 "Dual End".
Scheme Key
PE
Linie 1
Linie 2
Schnellabschaltung/
Fast Shutdown
2a
L ≤ 1,5 m
Netz/Line
X1
1
2b
X1
10
10
5
8
12
9
9
L
L
L
≤
≤
≤
≤
1,5 m
1
1
15
Netz/Line
et
et
et
et
et
tz/
t
z/
z/
z/
z
/Li
/Li
/L
/L
L
L
3
4
2
1
(1) DC link cable
• Length max. 3.0 m
(as per VDE 0100)
• DC link connector (X1)
3-pin:
DC Link +
n.c.
DC Link -
• Cross-section 2 x 25 mm
2
• Terminal X1 is to be tight-
ened to a tightening torque
of 2.5 Nm.
Table A.6 DC link connection between expansion module "Dual" and "Dual End"