Korber Solutions LTI MOTION ServoOne CM - Cooling the Devices

15
Mechanical installation
Operation Manual Expansion Module SO CM-E
1800.202B.0-01 Date: 02/2019
≥ 150
≥ 200
*)
≥ 300
SOCLP-BG4
SOCL-BG4
*) The bending radius of the connection cables must also be taken into account:
Figure 3.2 Mounting clearances ServoOne CM
NOTE:
Depending on the connection cables used (mains cable/motor cable), the
mounting clearances may increase signicantly due to the bending radii nec-
essary. For details see Operation Manual ServoOne CM BG3+4 and ServoOne
CM-P BG3+4.
3.3 Cooling the devices
Cooling air must be able to ow through the device (interior and heat sink) without re-
striction. If a thermal cut-out occurs, the cooling conditions must be improved.
Figure 3.3 Cooling air ows unhindered through the
device