- 24 -
Osc 1 Lo/Hi - switch at 32.
Osc 2 Lo/Hi - switch at 96.
VZone Osc1 001 - 064.
VZone Osc2 065 - 127.
Therefore:
Velocity 000-032 = Osc1, Lo
Velocity 033-064 = Osc1, Hi
Velocity 065-096 = Osc2, Lo
Velocity 097-127 = Osc2, Hi
3. I want to add another oscillator to a single oscillator Program, to
fatten it up. Is there any easy way to do this? For example,
Program G015 Tubular Bells.
There is a “Copy Oscillator” UTILITY that is highly useful for this kind of
thing. (2.1-1d) [Menu]-[Basic]-[Utility]-> Copy Oscillator. ☞ Parameter
Guide, Page 8.
After you copy it, the filters, amplitude envelopes etc. will all be exactly
the same. You could try a couple of things to fatten the sound:
1) Change the waveform (multisample) of Osc 2 to something warm, and
then mix the level of it in at a lower volume. (2.1-1b) Hi/Low Level. ☞
PG, Page 7.
2) Leave the waveforms the same (both Tubular Bells), but detune them
from each other and pan the 2 Oscillators left and right. This sort of
thing creates an interesting, stereo, chorused kind of image. (2.1-2c/3c)
Tune: try +5 or +10 on Osc 1, -5 or -10 on Osc 2. ☞ PG, Page 9. Then
set Pan L/R (5.1-1b/2b) 000/127. ☞ PG, Page 20.
3) As far as effects go, you could try adding a Graphic Equalizer in the
IFX, and boosting certain low frequencies.
4. If I edit a G Bank Program, how do I save it?
Once you edit it, you can't save it in the G Bank (G is a ROM Bank), but
you can save it in any other RAM Bank like any other Program (i.e. C or
D Banks) and use it from there.
To Next Page
Loading...
Need help?
General
