- 27 -
- Select Program A001. Make sure that [x] KARMA RT & Panel Setting is
checked. Press OK. You’ve now copied everything related to the KARMA
GE that was associated with that Program.
- (7.2-1c) [Menu]->[IFX]->[Setup]->[Utility]-> “Copy Insert Effects”. Press
OK. Select “A001” again, and turn “ALL” On (checked). Press OK.
- Check what the Bus Select for the Program is set to, so that you can
manually set it the same way. Go to Program Mode (7.1-1a) [Menu]-
>[Bus]->Bus Select. In the case of non-drum programs, this will almost
always be set to “IFX1”, but it doesn’t hurt to check. Drum Programs will
almost always be set to “use D.Kit”) Set the Combi the same way: (7.1-
1a) [Menu]->[Bus]-> Bus Select. With this and the preceding step, you
have now copied all the Insert FX settings from the Program to the
Combi.
- (7.3-1e) [Menu]->[MFX]->[Open]->[Setup]->[Utility]->“Copy Master
Effects”. Press OK. Select “A001” again, and turn “ALL” On (checked).
Press OK. You have now copied all Master FX settings from the Program
to the Combi.
- (1.1-1a) Set Tempo to 120 BPM (Same as original Program).
- (1.1-1c) Save the Combi, either by pressing the Sequencer Write
button, or by selecting “Write Combination” from the Utility Button.
At this point, it should sound and perform exactly the same as the
Program, but it is a Combi, and you can add more stuff to it.
☞ Parameter Guide, Pages 45, 57, 66, 68.
5. Is there a way to set the initial value for the programmable 4
real-time knobs (bank B) in a Combi? For example, say I tweak
the Release Time, and I want the Combi to come up that way?
You cannot store the settings of the 4 Real-Time Knobs (above the
Joystick) into a Combination. These are meant strictly for real-time
adjustment. The next time you load the Combi, they will default to “64”
(as if they were in the center position). The KARMA knobs in the KARMA
function operate differently - the settings you make on those can be
stored in the Combi.
If you want to change the release time permanently (in a Combi), you
would need to edit the release time for each Program in each timbre that
you want to be affected, and resave them (one by one in the Program
mode).
The only other kind of work around would be to use a KARMA GE to
modify the release time. A GE has 4 “Transmit CCs” parameters, that
each can be set to transmit a different single value of a selected CC when
To Next Page
Loading...
Need help?
General
