Korg KR-11 - Adding a Fill-in; Adding a Pre-Count

KR-11 - Playing back a rhythm pattern
10
| Adding a fill-in
A fill-in is a phrase used to accentuate the breaks in the rhythm, the start of a measure and so on.
1 When you press the FILL 1 or FILL 2 button during playback, a fill-in is added at the appropriate
timing.
The button you press blinks before the fill-in is played, lights up while the fill-in is playing, and
goes dark after the fill-in is finished.
| Adding a pre-count (a count-in before the rhythm
plays)
The pre-count is a count-in that starts before the pattern begins playing.
1 In pattern play mode, stop the playback.
2 Use the FILL 1 and FILL 2 buttons to select the pre-count sound (the respective button blinks).
FILL 1: side-stick
FILL 2: closed hi-hat
3 Long-press either the FILL 1 or FILL 2 button to show the number of pre-count beats in the
display.
4 Turn the tempo knob while holding down the button for the selected sound to set the number of
beats for the pre-count.
You can set the pre-count to a value from 2 to 8 beats.
5 Press to begin playback.
The pattern begins playback after the number of beats specified for the pre-count.
The FILL 1 and FILL 2 buttons go dark once the pre-count ends.