Korg KR-11 - Making Connections

KR-11 - Getting ready
7
| Making connections
Connecting the AC adapter (sold separately)
1 Connect the dedicated Korg AC adapter (sold separately) to the DC 9V jack.
Connecting headphones or monitor speakers
This unit can output sound to a pair of headphones or monitor speakers.
1 Turn the volume dial of the KR-11 all the way down.
2 Connect the 3.5 mm stereo mini phone plug of your headphones or similar device to the
headphone/line out jack.
3 Turn on the power of the KR-11.
4 Gradually raise the volume of the KR-11 and your monitor speakers to adjust the levels.
Note: No sound is heard from the built-in speaker while a plug is connected to the headphones/line out
jack.
Connecting pedal switches (sold separately)
You can connect a pedal switch (Korg PS-1 or PS-3, sold separately) to this unit to play back or stop
patterns, insert a fill-in, control the tempo or trigger a pad sound.
1 Connect the pedal switches (sold separately) to the FOOT SW 1 and 2 jacks.
Assign a function for one of the buttons on the panel to a pedal switch for operating the KR-11.
You can connect up to two pedal switches.
→Using the pedal switches
Make sure to only use the specified AC adapter. Using any AC adapter other than the specified
model could cause a malfunction.
Be sure to connect a stereo mini phone plug to the headphones/line out jack.
Do not use a four-conductor (TRRS) stereo mini phone plug, as this can cause a malfunction.
Be sure that your monitor speakers are turned off before you connect them to the KR-11.