18
operating systems are Mac OS X Yosemite or later, Windows 8.1 or
later (KORG BLE-MIDI Driver is required), and iOS 8.0 or later.
The wireless connection cuts out.
• Make sure that your computer or iPhone/iPad is not too far away
from the nanoKONTROL Studio.
There is no response from the software.
• Make sure that the nanoKONTROL Studio is correctly specified in
the MIDI port setup of your software.
• In order to use the functions of the nanoKONTROL Studio, your
software must be set up. For the setup, refer to “Operating Modes
and Software Setup” on page 7 and the instruction manual
for your software.
• Your software may not support some functions. Check the in-
struction manual for your software.
Buttons do not operate as indicated by the
nanoKONTROL Studio.
• Your software may not support some functions or may operate
differently.
• Be sure that the nanoKONTROL Studio is in a mode compatible
with your software. (→page.7: Operating Modes and Soft-
ware Setup)
The software does not respond to the transmit-
ted MIDI message.
• Verify the MIDI channel for messages transmitted by the
nanoKONTROL Studio is set to the same MIDI channel in your
software.
• If DAW software is being used, setup may be necessary in order
to use the nanoKONTROL Studio. For the setup, refer to “Operat-
ing Modes and Software Setup” on page 7 and the instruc-
tion manual for your DAW software.
The LED of a button does not light up when the
button is pressed.
• Check the settings for “Controller Mode” (page 14) and “LED
Mode” (page 14).
To Next Page
Loading...
Need help?
General
Weight and Dimensions
