17
Appendix
Restoring the Factory Settings
While holding down the Scene, and Stop buttons, turn the
nanoKONTROL Studio On. The Scene button and Scene LEDs 1
through 5 begin to blink. All settings of the nanoKONTROL Studio
will be restored to the factory settings when the blinking stops.
Restoring the factory settings takes several seconds after
the nanoKONTROL Studio is turned on. Never turn off the
nanoKONTROL Studio while the Scene button and Scene
LEDs 1 through 5 are blinking.
The factory settings cannot be restored when the mode
switch is set to “ ” (Battery).
Troubleshooting
Check the Korg website (http://www.korg.com/) for the most recent FAQ.
The nanoKONTROL Studio won’t turn on.
With a USB connection
• If the nanoKONTROL Studio is connected to a computer via a
USB hub, the nanoKONTROL Studio may not turn on due to insuf-
ficient power. In that case, the nanoKONTROL Studio should be
connected directly to the USB connector on the computer with-
out using a USB hub.
• There may be a problem with the USB cable currently used.
Check if the nanoKONTROL Studio can be turned on using the
supplied USB cable.
With a wireless connection
• Make sure that the Mode switch is set to “ ” (Battery).
• Make sure that the batteries have been inserted correctly, and
that they are not depleted. If the batteries are depleted, replace
them with new ones.
A wireless connection cannot be established.
• Verify that your computer or iPhone/iPad is compatible with Blue-
tooth 4.0.
• Verify that the operating system for your computer or iPhone/
iPad is compatible with Bluetooth Low Energy MIDI. Compatible
To Next Page
Loading...
Need help?
General
Weight and Dimensions
