97
Style Play operating mode
Mixer/Tuning: FX Send
Reference
Dry
Use this checkbox to turn the dry (direct) track signal on or off.
Note: If the track is sent to a separate output, no FX is sent to any
output. To program the output status for each track, see “Audio
Setup: Style/Kbd” on page 232.
On When checked, the direct, dry signal is sent to the
output, mixed with the FXs.
Off When unchecked, the direct, dry signal is
removed from the audio output, and only sent to
the FXs. The effected signal will still be panned
(in stereo FXs only) according to the Pan value.
Pan
Track position in the stereo field.
L-64…L-1 Left stereo channel.
C0 Center.
R+1…R+63 Right stereo channel.
Volume of grouped Style tracks
This parameter is a general offset applied to all Styles. Changing
the volume of the grouped Style tracks (Dr/Perc, Accomp, Bass)
is a global offset. When you choose a different Style, this offset
does not change.
These controls allows you to globally set the balance between the
Drum/Percussion, Bass and Accompaniment tracks. For exam-
ple, if you prefer Drums and Bass to be prominent to make them
have more ‘punch’, you can lower the grouped Accompaniment
tracks.
0…127 Volume level.
Volume of individual tracks
Track’s volume. This is the relative volume of each track, as saved
in the Style, Performance or STS. It may change when choosing a
different Style, Performance or STS.
0…127 MIDI value of the track’s volume.
Play/Mute icon
Track’s play/mute status.
Play status. The track can be heard.
Mute status. The track cannot be heard.
Mixer/Tuning: FX Send
This page lets you set the level of the track’s direct (uneffected)
signal going to the Internal FX processors. The effect processors
included in Pa2X are connected in parallel, so you can decide
which percentage of the direct signal can be effected.
In case you want to send all of a track’s signal to the effect (as
when using “insert” effects, like Rotary, Distortion, EQ…), just
set the Dry parameter to Off (see “Dry” above).
There are four Internal FX processors in Style Play mode (two
for Keyboard tracks, two for Style and Pad tracks). You can
assign them any kind of available effects, but we found it conve-
nient to arrange them in the following way, for most of the
Styles, STS and Performances included with the Pa2X:
FX A Reverb processor for the Style and Pad tracks.
FX B Modulating FX processor for the Style and Pad
tracks.
FX C Reverb processor for the Realtime (Keyboard)
tracks.
FX D Modulating FX processor for the Realtime (Key-
board) tracks.
Use the TRACK SELECT button to switch from Keyboard to
Style tracks, and vice-versa.
Send level (A…D)
0…127 Level of the track (direct) signal sent to the effect
processor.
Play/Mute icon
Track’s play/mute status.
Play status. The track can be heard.
Mute status. The track cannot be heard.
Sty
Track Out L/R
FX Processor
Track Out L/R
FX Processor
Sty
Sty
Sty
Sty
Sty
Sty
To Next Page
Loading...
