209
Sequencer operating mode
Effects: FX Select
Reference
Effects: FX Select
This page allows you to select effects to be assigned to the four
Internal FX processors (A-D).
Note: When you stop the Song, or select a different Song, the
default effects are selected again. You can, however, stop the Song,
change the effects, then start the Song again. Save the Song to per-
manently change the effects.
FX A…D
Effects assigned to the corresponding effect processors. Usually,
A and C are reverbs, while B and D are modulating effects (cho-
rus, flanger, delay…). For a list of the available effects, see the
“Advanced Edit” addendum in the Accessory CD.
FX Amount
Volume of the effect, that is added to the dry (uneffected) signal.
B to A, D to C
Amount of the B effect going back to the input of the A effect, or
of the D effect going back to the input of the C effect.
Mod.Track (Modulating Track)
Source track for modulating MIDI messages. You can modulate
an effect parameter with a MIDI message generated by a physical
controller.
Effects: FX A…D
These pages contain the editing parameters for the four effect
processors. Here is an example of the FX A page, with the Reverb
Smooth Hall effect assigned.
Selected effect
Select one of the available effects from this pop-up menu. This is
equivalent to the “FX A…D” parameters found in the “Effects:
FX Select” page (see above).
Parameters
Parameters may differ, depending on the selected effect. See the
“Advanced Edit” addendum in the Accessory CD for a list of
available parameters for each effect type.
Track Controls: Mode
Parameter
See “Track Controls: Mode” on page 102.
Track Controls: Drum Volume
Parameter
See “Track Controls: Drum Volume” on page 209.
Track Controls: Easy Edit
Parameter
See “Track Controls: Easy Edit” on page 104.
To Next Page
Loading...
