195
Sequencer operating mode
Sequencer Play - Main page
Reference
Track volume/status area
This area is where you can set the volume of each Song track,
and mute/unmute tracks.
Sliders and volume of the tracks
You can change the volume of each track by using the first eight
Assignable Sliders in the control panel. To make them act as vol-
ume controls, be sure the VOLUME LED over the SLIDER
MODE button is lit:
The Assignable Sliders correspond to the ‘virtual sliders’ in the
display. These are a graphical representation of each track’s vol-
ume.
You can change the volume also by touching a track, and using
the TEMPO/VALUE controls, or by touching a track and drag-
ging it in the display.
Use the TRACK SELECT button to switch between
the Song Tracks 1-8 and Song Tracks 9-16 views. The
Assignable Sliders LEDs show which view is currently
selected:
The Song Tracks 1-8 view shows Song tracks 1-8:
The Song Tracks 9-16 view shows Song tracks 9-16:
Slider Mode button status
Usually, the function assigned to the Assignable Sliders depends
on the status of the SLIDER MODE button. While in Sequencer
mode, you cannot save the SLIDER MODE status to a Perfor-
mance or STS, since Performances and STSs are disabled while
in this mode.
For details about the various Slider Modes, see “SLIDER
MODE” on page 7.
Track status icon
Play/mute status of the current track. Select the track, then
touch this area to change the track status. The status of Song
tracks is saved when saving the Song.
Play status. The track can be heard.
Mute status. The track cannot be heard.
Track names
Under the sliders, a label for each track is shown. Use the
TRACK SELECT button to switch between tracks 1-8 and 9-16.
Assignable sliders
Virtual sliders
Volume LED
Assignable Sliders LEDs
Abbreviation Track
T01…T16 Song tracks. Volume memorized into a Stan-
dard MIDI File. Play/mute status memorized
into the Standard MIDI File as well, and can be
read in Song Play mode.
Seq
To Next Page
Loading...
