Korg SDD-3000 PEDAL - Delay Type Selection

10
6. DELAY TYPE
1. SELECT button
Press this buon to switch the
delay type.
SDD-3000: Created in 1982,
this eect is still popular with
guitarists and sound engineers
worldwide due to its distinctive
sonic characteristics. The sound
that continues to be loved remains
unchanged, but its usability has
increased dramatically.
ANALOG: This models an analog
delay using a bucket-brigade
device (BBD). It recreates the
degraded sound quality and
distortion that occurs in analog
circuits.
TAPE: This recreates the distortion
and rotational irregularities of
tape.
MODERN: Faithful to the
original sound, this is a delay
of clean tones.
KOSMIC: This delay is applied
by adding pitch changes to
reverberation. By adjusting
the parameter seings, various
eects can be obtained, from
a natural reverb to a string-
like sound or an eerie deep
and low resonating sound.
Increase the FREQUENCY in
1. SELECT button
2. L/C/R button
the MODULATION section
to apply modulation to the
volume and obtain a more
fantastic eect.
REVERSE: This reverse delay
plays the delay sound in the
reverse direction.
PITCH: A pitch shier is arranged
in front of the delay. Use the IN-
TENSITY knob in the MODULA-
TION section to set the variable
width of the pitch. If you want the
pitch variable amount to be xed,
set the FREQUENCY knob to 0.
PANNING: This uses modulation
to control the orientation of the
delay output.
2. L/C/R button
On (LED lights up): This creates
a multi-tap delay that outputs to
the le, center and right.
The delay time and feedback
seings for the right channel
are disabled.
O (LED turns o): This
creates the normal stereo input/
stereo output delay.
Tip:
If the delay type is set to
PANNING, the L/C/R buon
functions as described below.
On (LED lights up): Panning
is normally centered on the
center.
O (LED turns o): The
panning range is normally on
the le. With the FREQUENCY
knob set to 0, the INTENSITY
knob can directly control the
orientation.
To change the delay time past
the ne adjustment range, press
the FINE buon so that the LED
turns o.
At this time, the value will
not change, even if the knob is
adjusted, until the knob is set
to match the current parameter
seing.
5. SYNC LED
This indicates the method for
seing the delay time.
Simultaneously press the R
TIME and FINE buons to
change the method for seing
the delay time.
SYNC on (LED lights up):
The delay time will be set as
a note synchronized to the tap
tempo set with the TAP/BANK
DOWN foot switch.
See page 18 “Seing the delay
time as a note”.
SYNC o (LED turns o): The
delay time will be set as time in
milliseconds.