Korg SDD-3000 PEDAL - Effect and Output Controls; Balance and Effect Mix Adjustment; Output Attenuator Settings

12
1. BALANCE knob
1. OUTPUT ATTENUATOR
switch
2. INTENSITY knob
Use this knob to set the variation
range of modulation. With delay
types PITCH and KOSMIC, the
INTENSITY seing species the
pitch variation.
3. FREQUENCY knob
Use this knob to set the
oscillating frequency of the
LFO for modulation.
Tip:
When the FREQUENCY
knob is set to 0, the INTENSITY
knob becomes the direct modu-
lation source.
9. EFFECT
1. BALANCE knob
Use this knob to adjust the
volume balance of the direct
sound that’s being input and
the delay sound that passes
through the delay module.
10. OUTPUT ATTENUATOR
1. OUTPUT ATTENUATOR
switch
Use this switch to select the
output level. Adjust this switch
according to the device that’s
connected to the output jack of
the SDD-3000 PEDAL.
–20dB: Audio devices and am-
pliers for musical instruments.
–10dB: Semi-professional devices
and other audio equipment.
+4dB: PA mixers and other
professional equipment.