Wave Sequencing 2.0
20
Mode = Single Multisample
MS (Multisample)
[List of Multisamples]
Select this parameter and then either move VALUE or press ENTER to bring up the Multisample Select popup.
Chan (Channel)
See “Chan (Channel)” on page 25.
S. Offset (Start Offset)
See “S. Offset (Start Offset)” on page 26.
Master Lane
When Use Master is On, the Master Lane restarts all of the other Lanes after either a specified number of beats or
elapsed time, depending on TEMPO On/Off (below). Unlike other Lanes, Master has no steps, so most of the front-
panel Lane controls don’t apply.
Use Master (SHIFT-MASTER)
[Off, On]
See “Use Master (SHIFT-MASTER)” on page 19.
Loop Duration
[TEMPO Off: 0.0013…120.0000 seconds]
[TEMPO On: 32nd-note triplet…2x breve]
If Timing Lane Tempo is Off, you can set the length of the Master Lane loop in seconds.
If Timing Lane Tempo is On, this sets the basic length of the Master Lane, relative to the system tempo.
x (Multiply Base Note by…)
[1…32]
This appears only if Tempo is On. It multiplies the length of the Base Note. For instance, if the Base Note is set to a
whole note, and Times is set to 3, the Master Lane will reset every three whole notes.
To Next Page
Loading...
