Effects
69
Effects
Overview
Each Layer has its own PRE FX, MOD FX, and DELAY. Additionally, the Performance has a master REVERB and
parametric EQ. See “Structure” on page 3.
SHIFT-press or double-press the effects buttons to turn them on and off.
Main page
Type (EFFECT TYPE)
[List of Effects]
For each effect, you can select a Type (or “algorithm”) and a Preset within that Type. For full lists of Effect Types, see
“Pre FX,” “Mod FX,” “Delay,” and “Master Reverb,” below.
“All” types (Delay All, Chorus All, etc.) let you select Presets from all related algorithms.
Preset
[List of Presets]
These are the presets available for the selected Type.
Wet/Dry (WET/DRY)
[Dry, 1:99…99:1, Wet]
This controls the balance between the original signal (Dry) and the effected signal (Wet).
Level controls
Additional level-related parameters may be available on-screen, depending on the effect Type.
Input Trim
[-Inf, -84.9…0.0 dB]
This controls the volume level into the effect. Use this to alter the response of effects such as the Waveshaper, or to
compensate for gain increases in effects such as the Talking Modulator.
Volume
[-Inf, -84.9…+12.0 dB]
This control the post-Drive output of the Guitar Amp. Use it to compensate for level changes caused by Drive.
Output Level
[-Inf, -84.9…0.0 dB]
This controls the output volume from the effect. Use it to compensate for level changes in effects such as the
Waveshaper.
Gain Adjust
[-Inf, -84.9…+24.0 dB]
This is similar to Output Level, but provides up to 24dB of gain. It appears only for the Modern Compressor.
To Next Page
Loading...
