Utility
75
Utility
System Setup
Set List
[List of Set Lists]
This selects the current Set List, which maps Performances to the SET LIST buttons. You can store many Set Lists, and
change between them as you like.
Octave (OCTAVE buttons)
[-4…+4]
This shifts the keyboard up or down by up to four octaves. It’s also generally controlled by the front panel octave
buttons (although these can optionally control scale selection, instead; see “Octave Selects Scale” on page 79).
Transpose
[–12…+00…+12]
This adjusts the pitch in semitone steps over a ±1 octave range.
Note: Transpose is affected by the Convert Position setting; see “Convert Position” on page 77.
Tune
[–50 (427.47Hz)…+50 (452.89Hz)]
This adjusts the overall tuning of the entire wavestate in one-cent units, over a range of ±50 cents. (A cent is 1/100 of a
semitone.) At the default of 0, A4 = 440 Hz.
The value shown for A4’s frequency assumes that the scale is set to Equal Temperament. If a different scale is
selected, the actual frequency of A4 may be different.
System ID
This number identifies the wavestate to computer hosts. If you have multiple wavestates, set each to a different
number.
MIDI
Global Channel
[1…16]
This is the basic MIDI channel for the wavestate. It applies to:
• MIDI sent from the built-in keyboard and controllers (except for Program Mod Knobs)
To Next Page
Loading...
