Selecting and Playing Sounds
5
2. Select the Category or Collection parameter, and turn the VALUE knob or press ENTER.
The Category or Collection Select popup appears. The lists will vary depending on the data type.
3. Select the desired Category or Collection, and press ENTER.
The display returns to the Performance Select popup, showing only sounds in the selected Category or Collection.
Using Sort Order
You can change the order in which sounds appear in the list. To do so:
1. In the list popup, press PAGE+.
The Filters & Sort Order page appears.
2. Select Sort Order, and turn the VALUE knob or press ENTER.
3. Choose the desired order.
You can choose from alphabetical (A-Z), reverse alphabetical (Z-A), or Category (sorted alphabetically within each
Category).
Using Set Lists
Set Lists let you group and order Performances for gigs or projects. A Set List has 64 Slots, arranged into four banks A-
D, corresponding to MIDI Program Change messages 0-63. Note that Set Lists don’t contain separate copies of their
sounds; they just point to Performances stored in the database.
To select sounds in the current Set List:
1. Press the SET LIST button, so that it is lit.
2. To select sounds in the current bank, press buttons 1-16.
3. To select from a different bank, first hold either SHIFT or SET LIST and then press 1/2/3/4 to select the bank.
Buttons 1-16 will then blink; press one to select a sound in the new bank.
If you select a sound using the display, buttons 1-16 will go dark. To return to the Set List, just press one of the buttons
again.
You can store many different Set Lists, and switch between them as desired. To select a different Set List:
1. Press UTILITY twice, to go to the System Setup page.
2. Select the Set List parameter, and press ENTER or turn the VALUE knob.
From this point, selecting Set Lists works just like selecting Performances, as described above.
To Next Page
Loading...
