Korg wavestate - LFOS; LFO Overview and Tempo Sync

Utility
78
Convert Position = Post-MIDI
Knob Mode
[Scale, Jump]
When you switch to a new Performance or select a different Layer, Wave Sequence Lane, Effect, Envelope, LFO, etc.,
the parameter values “underneath” the front-panel knobs will change—but the physical knobs won’t move
automatically. Knob Mode controls what happens when you move a knob.
Scale: This is the default. The physical position of the knob is mapped to the current parameter value. Moving the knob
counter-clockwise goes from the current value to the minimum; moving clockwise goes from the current value to the
maximum. If you turn the knob all the way to the left or right, the range is reset. See the graphic below.
Jump: When a knob is moved, the parameter value instantly changes to match the position of the knob.
Knob Mode set to Scale
MIDI CC Assign
You can control Scale Select and each Mod Knob directly from MIDI CCs. These CCs edit the assigned parameters,
just like moving the front-panel knobs. To modulate a parameter with variable intensity, and without causing edits to
the sound, use modulation instead. Some dedicated CCs cannot be assigned (CCs 1, 7, etc.).
Use ENTER + cursor (< or >) to jump forward or back by five parameters at a time.
Function Default CC assignment
Scale Select 9
Performance Mod Knobs 1…8 24…31
Layer A Mod Knobs 1…8 80…87
MIDI In
MIDI Out
Velocity
Curve
Transpose
Note Number changes
Transmitted Received
Velocity
Curve = 4
wavestate built-in keyboard
Scale
Tone
generator
No
Transpose
0 100
40
90
100
25 75
50
80
0
Initial knob position
Range is scaled around initial position
Knob moved to minimum
Range is reset to even distribution
Knob position Knob position
Current value:
Current value: