Vector
33
0<->3 and 1<->3: These loop forwards-backwards. For instance, 1<->3 makes the envelope play as follows: 0, 1, 2, 3, 2,
1, 2, 3 etc.
(Loop) Repeats
[Off, 1...126, Inf]
Off: The Vector Envelope proceeds to point 3, stays there until the note is released, and then proceeds to the Release
point.
1-126: The Vector Envelope will loop the specified number of times, hold at point 3 until the note is released, and then
proceed to the Release point.
Inf: The Vector Envelope loops as long as the note is held, and then moves to the Release point when the note is
released.
Time Scale
[0.01…100.00]
This speeds up or slows down the envelope as a whole, from 0.01 (1/100 of the original speed) to 100.00 (100 times the
original speed).
Joystick Edit
[Off, On]
On: When the Vector Env Position, X-Y, or Time pages are displayed, the VECTOR JOYSTICK edits the position
parameters instead of being a modulation source.
Off: The VECTOR JOYSTICK always acts as modulation source, and does not edit parameters.
Vector Volume (SHIFT-VECTOR)
[Off, On]
This enables and disables the direct control of volume by the Vector Joystick and Vector Envelope. The state is shown
by the front-panel VOL light. When Vector Volume is Off, the Vector Joystick and Vector Envelope are still available
as modulation sources.
To Next Page
Loading...
