Kostal KSEM - Page 48

48
3
© 2020 KOSTAL Solar Electric GmbH
Installation
Set up inverter in KOSTAL Smart Energy Meter. Do this
by performing the following steps:
1. Call up online interface of KOSTAL Smart Energy
Meter
Ch. 4.3
2. Go to Inverter > Devices and use Plus (+) to add the
PIKO 4.2-20 or PIKO EPC.
Parameter Value
Type
Select PIKO 4.2-20 /
PIKO EPC
IP address
Enter the inverter’s IP
address.
Maximum output power
Enter the inverter’s max. out-
put power. This is required if
a power limitation is set at the
grid connection point and has
to be calculated.
Open advanced settings
RS485 address
Enter the inverter’s RS485
address. This has to be
unique for each device (255
by default).
3. Press “OK” button to accept settings.
H
The inverter has been set up.
2
3
4
5
1