80
4
© 2020 KOSTAL Solar Electric GmbH
Operation and operating the device
Register configuration
Groups of registers can be selected here, which are
to be written in master mode. The system load of the
KOSTAL Smart Energy Meter can therefore be reduced
if all of the registers are not required. This may be nec-
essary if lots of devices are connected to the KOSTAL
Smart Energy Meter.
The arrow on the right can be used to drop down a
detailed list of registers, which are contained in the
respective groups.
The following registers can be activated or
deactivated:
Parameter Explanation
Current values total The current values for the entire
system (registers 0–27)
Current values phases The current values itemised by phase
(registers 40-145)
Energy values total The energy values for the entire
system (registers 512-551)
Energy values phases The energy values itemised by phase
(registers 592-791)
INFO
You will find information about the
respective registers in the “ KOSTAL
Smart Energy Meter - Interface De-
scription MODBUS” documentation
in the download area for the KOSTAL
Smart Energy Meter.
To Next Page
Loading...
