Analog signals: Contains measured values and mA output for each channel.
Fig. 4.13. Analog signals.
Event log: Event log stores changes made after start setup. Stores also all boot-ups. Holds last 250
events.
Datalog:
Fig. 4.14. Datalog menus.
Contains measured minimum and maximum signals and monitored internal temperature data since
the last reset. Please; reset during start-up.
Check alarms: List of maintenance alarms, which are active at a moment. Used for troubleshooting.
Identification:
Fig. 4.15. Identification menus.
Contains ID and version information.
Default settings: Reset to configuration settings. Used e.g. if the settings are changed by accident.
KB² Man W41100099V1.218August 2012
To Next Page
Loading...