To control device signals:
1. In the Navigation pane, Select Device Management>Control. The Control tab appears.
Figure 36: Control Tab
2. Next to the device ID, mark the checkbox to make changes to a specific device.
3. Open the Audio Direction drop-down box to define the direction of the audio port.
4. Open the IR Direction drop-down box to define the IR signal as IR in or IR out.
5. Define the RS-232 parameters: the baud rate, data bit, parity and stop bits.
6. Restart/Reset devices:
▪ Click Restart/Reset in the heading area to restart/reset selected devices.
▪ Click Restart Reset in a certain row to restart/reset a specific device.
7. Click APPLY.
Device signals are managed.
Creating Groups
Create groups to manage encoders and decoders easily, for example, by routing a group of
decoders to the same encoder.
• Only devices of the same type can be grouped. For example, encoder groups or
decoder groups.
• You can assign a device to more than one group.
• If a device is assigned to a video wall, it cannot be assigned to a group.
To Next Page
Loading...