Kramer Electronics Ltd.
KT-107, KT-107RB - Upgrading the Firmware
Prepare the KT-107 for Firmware Upgrade
To prepare the KT-107:
1. Verify that the battery is at least 70% charged.
2. Disconnect the panel from its mount (see Mounting the KT-107 on page 9).
3. Power-off the panel (from behind or via the Kramer control button on the front of
the Touch Panel).
4. Connect the PC USB port directly to the micro-USB port on the rear of the
KT-107 (do not use the port on the mount) via a USB cable with data-transfer-capabilities.
You can connect several Touch Panels to upgrade simultaneously.
Carefully place the KT-107 in a way that does not cause damage to the USB cable or port.
Upgrade the Firmware via PC
To upgrade the firmware:
1. In the ‘KT FW Upgrade Tool’ folder, double-click ‘Kramer Touch Panel FW Upgrade
Tool.exe’.
The FW Upgrade Tool window appears:
Figure 33: Firmware Upgrade Tool
To Next Page
Loading...
