TP-590Rxr - Operating the TP-590Rxr Remotely Using the Web Pages
The UDP port number of the device. To set a new UDP
port number, enter the new valid port number or use the
spin controls and click Set
The TCP port number of the device. To set a new TCP
port number, enter the new valid port number or use the
spin controls and click Set
All settings
Configuration Buttons
Click Load to retrieve a saved configuration. Click Save
to save the current configuration
Click to reset the device to factory default parameters
Note: When saving the configuration using Internet Explorer 11 press CTRL+S.
8.3.1 Turning DHCP On and Off
By default DHCP is turned off.
To turn DHCP on:
1. Click DHCP ON.
The Communication Warning shown in Figure 12 is displayed.
Figure 12: Turning DHCP On Communication Warning
2. Click OK.
DHCP is turned on. The next time the TP-590Rxr is booted, you must reload
the Web pages using the IP address issued to the TP-590Rxr by the DHCP
server.
To turn DHCP off:
1. Click DHCP OFF.
The DHCP OFF dialog box Figure 13 is displayed.