Kramer VM-214DT

Kramer Electronics Ltd.
VM-214DT – Protocol 3000
35
Kramer Protocol 3000 Commands
Command
Description
#
Protocol handshaking
AUD-LVL
Set/get audio level in specific amplifier stage
AV-SW-TIMEOUT
Set/get video auto-switch timeout
BUILD-DATE?
Read device build date
CPEDID
Copy EDID data from the output to the input
DIR
List files in device
DISPLAY?
Get output HPD status
DPSW-STATUS?
Get the DIP-switch status
ETH-PORT
Set/get Ethernet port protocol
FACTORY
Reset to factory default configuration
FPGA-VER?
Get current FPGA version
FS-FREE?
Get file system free space
GEDID
Read EDID data
GET
Get file
HDCP-MOD
Set/get HDCP mode
HDCP-STAT?
Get HDCP signal status
HELP?
Get command list
LDEDID
Write EDID data to input
LOGIN
Set/get protocol permission
LOGOUT
Cancel current permission level
MODEL?
Read device model
MUTE
Set/get audio mute
NAME
Set/get machine (DNS) name
NAME-RST
Reset machine name to factory default (DNS)
NET-DHCP
Set/get DHCP mode
NET-GATE
Set/get gateway IP
NET-IP
Set/get IP address
NET-MAC?
Get MAC address
NET-MASK
Set/get subnet mask
PASS
Set/get Password
PING
Sends ICMP ECHO
PROT-VER?
Get device protocol version
RESET
Reset device
ROUTE
Set/get layer routing
SECUR
Start/Stop Security
SIGNAL?
Get input signal lock status
SN?
Read device serial number
VERSION?
Read device firmware version