VP-551X – Operating and Controlling VP-551X
Setting the Audio Source
To set the audio source:
1. On the front panel press MENU. The menu appears.
2. Click Audio and define the audio parameters according to the information in the
following table:
Set the analog audio input volume for HDMI 1 to HDMI 8, PC and CV.
Set the LINE OUT output volume
Set the audio delay time to 40ms (default),50ms, 60ms to 200ms
(in 10ms steps).
Set dynamic range compression Off (default) or On.
Set the output bass level.
Set the output treble level.
Set loudness Off (default) or On.
Set audio mute to Off (default) or On.
Set audio speaker mute to Off (default) or On.
Set each HDMI input (1 to 8) audio source to Automatic (default), Analog or
Embedded.
Set to Off (default), Mixer, Talkover or Mic Only.
Set to Mic 1 (default), Mic 2 or Both.
When Mic Mode is set to Talkover (see Talkover Mode on page 15), set the
following:
Set the depth value to determine the decrease of the audio
level during microphone takeover (press + to further
decrease the talkover audio output level; press – to lessen
the talkover output audio decrease level).
Set the trigger value to determine the microphone threshold
level that triggers the audio output level decrease.
Set the attack time to set the transition time of the audio level
reduction after the signal rises above the threshold level.
Set the hold time to define the time period talkover remains
active although the signal falls below the threshold level (for
a short period of time).
Set the release time to define the transition time for the
audio level to return from its reduced level to its normal level
after the Hold Time period.
Set microphone volume (MIC 1, MIC 2).
Apply DSP (default) to the embedded audio or ByPass it.
To Next Page
Loading...
