EasyManua.ls Logo

Kramer VP-701XL

Kramer VP-701XL
69 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
17
PAN Jumps to the Zoom pan menu item and allows immediate
panning of a zoomed image using multi-directional switch.
AUTO
TRAK
Activates Auto Trak for the analog RGB input
ASPECT
RATIO
Changes the aspect ratio of the output. This cycles between 3
different settings.
SIZE Jumps to the ‘Shrink’ menu item and allows immediate
adjustment of PIP size.
POS Jumps to the Shrink pos % menu item and allows immediate
adjustment of PIP position.
LOCK Sets Lock mode to Genlock.
This locks the unit’s output to the current Lock source.
See ‘Adjust outputs’ menu details.
KEY Enables keying see ‘Adjust keyers’ menu.
(Key color defaults to black, so black foreground will disappear.)
MIX Sets Lock mode to Lock & Mix, to overlay onto the current Lock
source. Use with the KEY and FADE buttons for more flexibility.
A 2
nd
press will swap foreground and background.
See ‘Adjust outputs’ menu details.
FADE Fades out the current image – fades back in on next press.
PIP Activate picture-in-picture mode.
(Activates and deactivates the Shrink value in the ‘Adjust
windows’ menu in the OSD)
RESTORE Hold in briefly to restore to last-saved (power-on) defaults – this
is useful to ‘escape’ from non-displayable configurations. Hold in
for longer (two beeps) to perform a Factory reset of user settings.
STANDBY Hold in to put the unit into Standby (power-save) mode.
Hold in briefly to come out of Standby mode.
5.4 Special button combinations and functions
Various button combinations are available to perform certain functions:
These buttons combinations only work when the unit is switched
on and active i.e. with the STANDBY/ON LED off.
5.4.1 Storing the current settings
Press and hold the centre ‘MENU’ button for a few seconds. This will store all
settings in non-volatile memory so that they will be used as the default settings
when next powered on.
5.4.2 Locking front panel buttons & IR remote control
This can be performed by pressing STANDBY/ON and FREEZE at the same time.
All front panel buttons and IR remote commands will be disabled, with the

Table of Contents

Related product manuals