Kramer VP-701XL

34
Film 3:2 Enables 3:2 pull down conversion of the incoming NTSC
video. (This option is ignored if the source is not NTSC
video).
M. Comp Low
M. Comp Med.
M. Comp High
Enables Pixel Adaptive Motion Compensation. Three levels
are available with ‘Low’ providing the least compensation
for Motion and ‘High’ providing the most compensation.
8.6.2 CV & YC Source Menu Items
Of the above Source Menu items, the Autoset sense and Autoset status functions,
RGB type and Pixel phase are specific to RGB signals only. The rest of the Source
menu items function with RGB, CV or YC type signals. In addition, there are four
additional Menu items that are only used with CV or YC type signals and these are
explained below:
Adjust the Brightness and Contrast of the image to your requirement.
Saturation is the amount of color present in the image. Hue is the color “tint”
parameter and the adjustment range is +90 degrees through to -90 degrees with 0
being the default.
Within limits, you can enhance or soften the appearance of detail within an image.
The Sharpness values go both negative and positive, with 0 being the default. Note
that over-enhancing an image has the side effect of making it appear to be noisy
and under-enhancing an image gives the appearance of poor video quality.
On occasion, a video source will have the color portion of the signal offset from the
luminance portion. If you’ve ever seen a poor quality comic book that has the
outline of the cartoon character’s head in one place on the page but the flesh tones
for the head offset slightly, you are seeing the print equivalent of Luminance to
Chrominance Phase Delay.
Source: YC1
Bright [100] Contrast [100]
Source: YC1
Satur [100] Hue [0]
Source: YC1
Sharpness [0]
Source: YC1
Luma delay [ 0]