33
There are several types of signals that are called RGB signals as a generic term.
Each has slightly different characteristics that set it apart from similar RGB signals
– such as how the synchronization signal is sent. This menu item lets you set the
input type to use.
Available options are:
RGBHV - Red, Green, Blue image plus Horizontal and Vertical Sync
RGBS - Red, Green and Blue plus a single TTL level Sync signal
RGsB - Red, Green and a Blue image plus a sync signal superimposed on the
Green channel
YUV - also know as YPbPr and common for 720p and 1080i formats, where a sync
signal is present on the Y signal
This menu item lets you adjust the individual RGB or YUV/YPbPr signals, in case
one component is at a different contrast to other, or if they all need to be boosted or
lowered.
An interlaced input consists of two fields separated in time. Both fields are required
in order to make up the full resolution input image, but since they are sent one after
the other, a moving image will have “motion artifacts” if the two fields are simply
combined together. The most common artifact is a blurring at the point of
maximum movement within an image. Your unit provides some tools to minimize
the effects of de-interlacing of an image.
The following options are available for this menu item:
Mode Function
Normal The two interlaced fields are simply combined together.
This will often show artifacts on moving images, but can be
used when the input is known to be still.
Auto Automatically selects Film 3:2 or Medium Range Motion
Compensation (M. Comp Med.) depending on whether Film
Mode is detected or not. For 1080i sources, a special de-
interlacing mode is selected to eliminate combing effects.
Source: RGB1
RGB input type [RGBHV]
Source: RGB1
RGB contr. [100] [100] [100]
Source : RGB1
De-int [M.comp med]
To Next Page
Loading...
