60
Storage humidity: 10% to 85%, non-condensing
15.10 Power Requirement
External power supply: 12V DC @1A maximum.
Actual current consumption varies between units.
Internal over-voltage & over-current protection.
Full PSU specification: 12v DC regulated 1Amp PSU with a 2.5mm locking center-
pin positive DC power connector. A non-locking 2.5mm DC power connector will
also fit.
15.11 Control Methods
The unit can be controlled locally via the front panel buttons and on-screen display
(OSD), remotely via the RS-232 interface (as applicable) using a D9 female
connector or again remotely via the Infrared remote using the infra-red remote unit.
15.12 Accessories Included
Varies depending on unit – see earlier in manual
15.13 Mechanical
Size (H x W x D): 1.2”x7.9”x3.5” (30x200x89mm)
Weight (Net): 1.3 lbs (580g)
To Next Page
Loading...
