58
15 SPECIFICATIONS
See product front and rear diagrams for details of product I/O. Not all units in the
series have all the inputs and outputs listed here.
15.1 Video Inputs
Input impedance: 75 Ohm
Television standards supported: NTSC and PAL
Composite video via BNC
S-Video (YC) via 4-Pin mini-DIN Connector
CV/YC video decoder: 8-bit Digital
De-Interlacing (NTSC / PAL up-conversion only): pixel-level motion adaptive
Comb filter decoding: adaptive
Film mode (NTSC) 3:2 pull down for up-conversion
CV/YC Video adjustments: contrast, brightness, saturation, hue (NTSC)
CV/YC sub-carrier lock range: +/- 200Hz for NTSC Operation, +/- 250Hz for PAL
Operation
15.2 Computer Input
Analog RGB/YPbPr via HD15 into 75 Ohm, supporting RGBHV, RGBS, RGsB,
YPbPr, auto-terminating into 75 Ohm
Digital sync (in RGBHV or RGBS mode): TTL Level, 10K termination, pos or
negative
Analog sync (in RGsB, YPbPr, YUV modes): 0.3v negative.
RGB Level Range: 0.5-2.0 Vp-p approx.
Scan Rate Detection: automatic
PC Resolutions: any up to 2048x2048
HDTV Resolutions: any up to 1080p
Max horizontal scan rate: 150kHz
15.3 Video Outputs (not present on all units)
Output impedance 75 Ohm
Television standards supported: NTSC and PAL
Composite Video 1v p-p via BNC
S-Video (YC) 1v p-p via 4-pin mini-DIN
CV/YC Video encoder: 8/10-bit Digital
15.4 Computer Outputs
Analog output impedance 75 Ohm
Analog RGBHV, RGBS, RGsB, YPbPr (0.7v RGB / 1.0v sync-tip to white, approx.
0.4v DC offset)
To Next Page
Loading...
