Kramer VP-701XL

25
This menu item allows you to select the type of signal output your unit will provide.
Types of output vary depending on the resolution selected and include various
types of component signals Y/R-Y/B-Y or YPbPr, the full range of RGB type signals
RGBHV, RGBS and RGsB (Sync on green).
This menu item is only available when the Output resolution is set to PAL or NTSC.
With this you can change the output type to the PAL or NTSC standard with the
further option of changing the output to the additional PAL & NSTC standards such
as PAL-M or PAL-N. SECAM is also available as an output, provided the ‘Output
res’ is set to PAL / 50Hz.
Sets the value of the fixed background color, which is present when PIP is used
with no Lock source background displayed. This menu item is only available for
units with overlay, keying and fading abilities.
8.4 Items Associated with the Adjust windows group
This menu group allows adjustment to be made to window specific parameters
such as the window source, its position, size and zoom level.
The source display screen allows the input source for the currently selected window
to be changed. The top line of the display shows the detected characteristics of
the signal. Valid Input sources match those available on the front of the unit
If you have Lock mode active (set to either Genlock or Lock &
Mix) then you will be restricted in your choice of Source. This is
because you cannot overlay one CV or YC source over a
different CV or YC source, or one RGB/YUV source over another
RGB/YUV source – you are restricted to overlaying CV/YC over RGB/YUV, or
RGB/YUV over CV/YC (the exception is where you can overlay one source over
itself). Turn Lock mode off in order to select a wider range of sources.
Adjust outputs
Output type [RGBHV]
Adjust outputs
Back Y/U/V [ 16] [128] [128]
Adjust outputs
Out std [NTSC / PAL]
NTSC / 60Hz
Source [ YC1]