3-2 Issue 03, 04/2005 Krautkramer DynaPOCKET
3.1 Preparation
Inserting batteries
You can operate the DynaPOCKET with AAA-sized
AlMn batteries or rechargeable NiCd or NiMH batteries.
You need 2 pieces of each. AlMn batteries are recom-
mended for the longest operating time.
– Open the cover of the battery compartment.
– Insert the batteries while observing the correct
polarity as shown in the battery compartment.
– Replace the lid and snap the cover back in place.
The lock must perceptibly snap in.
H Notes:
Remove the batteries from the instrument if you’re not
going to use it for a longer period of time!
Used or defective batteries are special waste and must
be disposed of according to the legal requirements!
Operation Preparation
The following icon indicates the battery voltage is get-
ting too low:
In this case, exchange the batteries immediately. The
DynaPOCKET automatically switches off if the battery
voltage is too weak to ensure reliable operation. It may
happen that the instrument cannot be switched on
again without battery exchange.
H Note:
If you remove the batteries from the instrument for
more than about 3 minutes, the last settings are lost
(e.g. measurement mode and hardness scale).
You will find more information about batteries in
chapter 5.1.
To Next Page
Loading...
