3-10 Issue 03, 04/2005 Krautkramer DynaPOCKET
Operation Selecting instrument settings
Hardness scale
In the default setting, the measurement result is dis-
played as HL value (Leeb’s hardness according to the
rebound hardness testing method). You can select an-
other hardness scale if required.
Setting options:
HS Shore
HB Brinell
HRB Rockwell B
HRC Rockwell C
HL Leeb
HV Vickers
N/mm2 Tensile strength
– Press the two keys simultaneously to select the
setup mode.
– Select the parameter SCAL with the MODE/CLEAR
key.
– Press the ENTER/SET key to change the current
setting.
– Use the MODE/CLEAR key to confirm the selected
setting, and press the key again, if necessary, to go
to the measurement mode.
The selected new hardness scale is shown in the dis-
play in the area above or below the measured value.
To Next Page
Loading...
