Krautkramer DynaPOCKET - Default Chapter; Table of Contents

Krautkramer DynaPOCKET Issue 03, 04/2005 0-3
Content
1 Introduction ...................................... 1 -1
1.1 Safety information .................................. 1 -2
Batteries ................................................... 1 -2
Software ................................................... 1 -2
1.2 About this manual .................................. 1 -3
Important information ................................ 1 -3
1.3 Layout and presentation in this manual 1 -4
Attention and note symbols ...................... 1 -4
Listings ..................................................... 1 -4
Operating steps ........................................ 1 -4
1.4 Prerequisites for hardness testing ......... 1 -5
Operator training ....................................... 1 -5
Technical test requirements ...................... 1 -6
Choice of the appropriate test equipment .. 1 -6
1.5 Krautkramer DynaPOCKET ..................... 1 -7
1.6 Important information about hardness
testing using the DynaPOCKET ............. 1 -9
Test material ............................................. 1 -9
The rebound method ................................. 1 -9
Conversion of hardness values ............... 1 -10
2 Scope of supply and accessories .. 2 -1
2.1 Scope of supply ...................................... 2 -3
2.2 Recommended accessories ................... 2 -5
2.3 Spare parts requirements ....................... 2 -6
3 Operation .......................................... 3 -1
3.1 Preparation .............................................. 3 -2
Inserting batteries ..................................... 3 -2
3.2 Fundamental principles of operation .... 3 -3
Display and keys ...................................... 3 -3
How to handle the impact device .............. 3 -5
3.3 Hardness measurement .......................... 3 -6
Switch-on .................................................. 3 -6
Switch-off ................................................. 3 -6
Carrying out a measurement ..................... 3 -6
Closing a measurement set ...................... 3 -7
Deleting measured values ......................... 3 -7