Krautkramer DynaPOCKET - Closing a Measurement Set; Deleting Measured Values

Krautkramer DynaPOCKET Issue 03, 04/2005 3-7
OperationHardness measurement
Closing a measurement set
If you use measurement sets, you can close a mea-
surement set at any time and start a new set. The pre-
vious measured values stored for the calculation and
their displayed arithmetic mean are deleted.
– Press the ENTER/SET key. The actual average
value flashes.
– Press the ENTER/SET key a second time to close
the current measurement set and to delete the
stored values. The display indicates 0 as a current
reading.
Deleting measured values
If you are using measurement sets, you can delete the
most recent reading at any time to remove an erraneous
measurement from the statistical average.
– Press the MODE/CLEAR key for about 2 seconds.
The last value measured flashes.
– Press the MODE/CLEAR key a second time to
delete the value. The measured value is deleted and
the average is automatically recalculated.
– You can repeat the procedure to sequence through
the readings deleting each until all measured values
are deleted.
H Note:
As long as the display is flashing, you can abort the
deletion.
– Briefly press the ENTER/SET key to cancel the
process of deleting.